Affordable Home Geothermal Systems Done Right.
Get the most energy efficient, money saving,
earth friendly home comfort system available.
Geothermal System Service Request
* Indicates required questions
Name *
First
Last
Email *
Phone # *
How can we help you? *
How did you hear about us?
Select the service you need  *
Do you require immediate service?  *
Experience the Vander Hyde Difference!
Integrity, Professionalism, and Compassion in everything we do.
The Vander Hyde Team
  • FREE Estimates
  • On-time Appointments
  • Licensed & Insured
  • Exceptional Product Lines
  • 24/7 Emergency Service
  • 1yr Labor/Materials Warranty!

Certified Geothermal HVAC system installer for Grand Rapids and the surrounding areas 

Let us show you how efficient and economical geothermal heating and cooling systems are.


Geothermal Systems are not a new concept

Homeowners have been using geothermal HVAC systems to heat and cool their homes for more than 40 years.  The earth, below the frost line typically stays about 50 degrees F.  Using water pipes, geothermal systems capture a consistent midpoint temperature, and use it quickly and efficiently heat or cool your home. This shortcut to ideal home climate is actually moving heat rather than making it from scratch. 

Most HVAC systems are responsible for more than half a home’s energy consumption. With the fuel savings and federal tax credits and state incentives, the system can pay for itself in savings in only 3-5 years. 

How Geothermal heating works:

In the heating mode, the water circulating in the earth loop is colder than the surrounding ground. This causes the water to absorb energy, in the form of heat, from the earth. The water carries this energy to the heat exchanger in the pump. In the heat exchanger, refrigerant absorbs the heat energy from the water. The water now leaves the heat exchanger at a colder temperature, and circulates through the earth loop to pick up more energy. The refrigerant gas, which contains energy gained from the earth loop, travels from the heat exchanger to the compressor. In the compressor, the refrigerant temperature rises to 160°. The superheated refrigerant travels to the air heat exchanger. Here, the heat pump's blower circulates air across the air coil, increasing the temperature of the air, which is blown through ductwork to heat the home. After refrigerant releases its heat energy to the air, it then flows to the earth loop heat exchanger to start the cycle again. Learn More

How Geothermal cooling works

In the cooling mode, the water circulating in the earth loop is warmer than the surrounding ground. This causes the water to release energy, in the form of heat, into the earth. The water, now cooler from traveling through the ground now flows to the heat exchanger in the heat pump. In the heat exchanger, hot refrigerant gas from the compressor releases its heat into the water.

This causes the water to increase in temperature, and release the heat to the ground. The refrigerant, which has released its heat energy and became a cold liquid, now travels to the heat exchanger. Here the heat pump's blower circulates warm, humid air across the cold air coil. The air is then blown through ductwork to cool the home. The refrigerant in the air coil picks up the heat energy from the air, and travels to the compressor. When the refrigerant leaves the compressor, it then flows to the earth loop heat exchanger to start the cycle again. Learn More


Experience matters!

Vander Hyde licensed contractors offer the best in geothermal HVAC system installation to residents in Grand Rapids, Wyoming, Kentwood, Forest Hills, Grandville, Holland, Muskegon, and surrounding areas. Call (616) 454-5400 for a No Cost, Professional, Onsite Estimate​!

616-202-3477
989-623-4113